Dog and cat house
A pet house sized to your pet. Set the width and depth, the height of the walls and the size of the door, and raise the floor off the ground. The roof lifts off in one piece to clean the inside.
Summary
Parts
Cutting sheets
Assembly
What you get
- At the starting size: 23 5/8" × 31 1/2" · 31 1/2" high at the ridge · interior of 21 11/16" × 30 1/16" · door of 10 1/4" × 14 15/16". 7 parts on 2 sheets of 96" × 48".
- A DXF and an SVG of every sheet, nested, with outside cuts, inside cuts and dog-bones on separate layers, at real size.
- A PDF assembly guide with the parts list, the cutting sheets and numbered steps, in your units.
- A license to sell what you make with the plan.
- Free 3D preview before you pay, and a fit guarantee: if a joint does not fit your material, we help you or give your credits back.
Questions
How do I size the door?
The width of the chest plus a few fingers, and about three quarters of the height at the shoulder. For a cat, about 6 1/4" wide and 8" high (160 by 200 mm).
What material should I use outdoors?
Marine or phenolic plywood, with every edge sealed. MDF and particleboard swell with the first rain.
How do I clean it?
Leave the roof tenons without glue and the whole roof lifts off in one piece. Glue them if you want it fixed.
Is it a certified product?
No. These are plans, not a certified product. Sand the door edge well, seal and finish it, and check that it suits your pet.
Which software opens the DXF?
Any CAM program that reads DXF, such as VCarve, Aspire, Fusion, Alphacam or Mach-compatible tools. Outside cuts, inside cuts and dog-bones are on separate layers, and the files are generated at real size.