Hexagon shelf
A honeycomb on your wall. Each hexagon is a module, so you choose how many to make and how wide. A front frame hides the joints and the back has holes for hanging.
Before you cut: the starting values (a 3 mm sheet and a 0.15 mm kerf) are typical, not yours. Measure your real thickness and kerf and cut a small test in a scrap first: a square and one joint. How to do it.
Summary
Parts
Cutting sheets
Assembly
What you get
- At the starting size: 3 modules of 11 13/16" × 10 1/4" and 4 15/16" deep · usable opening of 11 3/8" point to point. 24 parts on 6 sheets of 24" × 12".
- An SVG with the cuts in red and the engraving in blue, and a DXF of every sheet, at real size and nested.
- A PDF assembly guide with the parts list, the cutting sheets and numbered steps, in your units.
- A license to sell what you make with the plan.
- Free 3D preview before you pay, and a fit guarantee: if a joint does not fit your material, we help you or give your credits back.
Questions
Can I add more hexagons later?
Yes. Cut as many modules as you like in the same size and join them side by side.
What material and thickness should I use?
Use 1/8" (3 mm) birch plywood, basswood plywood or MDF. Measure the real thickness with calipers and enter it under Material, laser and sheet, because the joints are calculated from it.
Do I need to set the kerf?
Yes, once. Cut a 3/4" (20 mm) square, measure it and enter the difference as your kerf. The joints are compensated, so the parts press-fit. The default suits most CO2 lasers.