Cut-out lantern
A lantern that throws a pattern of light on the wall. Choose circles or diamonds, set the size of the pattern for softer or brighter light, and set the height. It is meant for an LED candle.
Before you cut: the starting values (a 3 mm sheet and a 0.15 mm kerf) are typical, not yours. Measure your real thickness and kerf and cut a small test in a scrap first: a square and one joint. How to do it.
Summary
Parts
Cutting sheets
Assembly
What you get
- At the starting size: 4 5/16" × 4 5/16" × 6 11/16" · 244 cut-outs of 0.354". 5 parts on 1 sheet of 24" × 12".
- An SVG with the cuts in red and the engraving in blue, and a DXF of every sheet, at real size and nested.
- A PDF assembly guide with the parts list, the cutting sheets and numbered steps, in your units.
- A license to sell what you make with the plan.
- Free 3D preview before you pay, and a fit guarantee: if a joint does not fit your material, we help you or give your credits back.
Questions
Is it safe with a real candle?
No. Use LED candles only, because wood burns and a real flame inside is dangerous.
What material and thickness should I use?
Use 1/8" (3 mm) birch plywood, basswood plywood or MDF. Measure the real thickness with calipers and enter it under Material, laser and sheet, because the joints are calculated from it.
Do I need to set the kerf?
Yes, once. Cut a 3/4" (20 mm) square, measure it and enter the difference as your kerf. The joints are compensated, so the parts press-fit. The default suits most CO2 lasers.