Lattice leg
A lattice pillar that clicks together without glue. Four faces with a pattern of diamonds, honeycomb, circles, stars or slats lock with hooked tabs and come apart by lifting a side. Choose the pattern, the cell size and the size.
Before you cut: the starting values (a 3 mm sheet and a 0.15 mm kerf) are typical, not yours. Measure your real thickness and kerf and cut a small test in a scrap first: a square and one joint. How to do it.
Summary
Parts
Cutting sheets
Assembly
What you get
- At the starting size: 7 1/16" × 7 1/16" × 13 1/8" · diamond lattice · hooked tabs, removable. 5 parts on 4 sheets of 24" × 12".
- An SVG with the cuts in red and the engraving in blue, and a DXF of every sheet, at real size and nested.
- A PDF assembly guide with the parts list, the cutting sheets and numbered steps, in your units.
- A license to sell what you make with the plan.
- Free 3D preview before you pay, and a fit guarantee: if a joint does not fit your material, we help you or give your credits back.
Questions
How does it lock without glue?
Each side has hooked tabs that enter slots in the front and back faces. Lowering the side hooks the tab around the face, and lifting it takes the piece apart.
Can I use it with a light?
Yes. An LED inside throws the pattern on the wall around the piece. Use LED lights only, because wood burns.
What material and thickness should I use?
Use 1/8" (3 mm) birch plywood, basswood plywood or MDF. Measure the real thickness with calipers and enter it under Material, laser and sheet, because the joints are calculated from it.