Phone and tablet stand
A stand made for your device, case included. Enter its thickness and the tilt you want, and the channel is cut to hold it with the charging cable running through the middle.
Before you cut: the starting values (a 3 mm sheet and a 0.15 mm kerf) are typical, not yours. Measure your real thickness and kerf and cut a small test in a scrap first: a square and one joint. How to do it.
Summary
Parts
Cutting sheets
Assembly
What you get
- At the starting size: 3" × 3 1/8" × 4 5/8" · 65° · channel of 1/2" for a device 0.433" thick. 5 parts on 1 sheet of 24" × 12".
- An SVG with the cuts in red and the engraving in blue, and a DXF of every sheet, at real size and nested.
- A PDF assembly guide with the parts list, the cutting sheets and numbered steps, in your units.
- A license to sell what you make with the plan.
- Free 3D preview before you pay, and a fit guarantee: if a joint does not fit your material, we help you or give your credits back.
Questions
What angle should I choose?
Between 60° and 70° works well when you look at the screen sitting down. 90° would be upright.
What material and thickness should I use?
Use 1/8" (3 mm) birch plywood, basswood plywood or MDF. Measure the real thickness with calipers and enter it under Material, laser and sheet, because the joints are calculated from it.
Which software opens the files?
The SVG opens in LightBurn, xTool Creative Space, Glowforge, Inkscape and Illustrator. The DXF opens in most CAD and CAM programs. The sizes are real, so nothing needs scaling.