Serving tray with handles
A tray with a handle at each end. Choose ears that curve upward, an arched profile or straight ends, set how much the sides dip in the middle, and make the handle wide enough for your fingers.
Before you cut: the starting values (a 3 mm sheet and a 0.15 mm kerf) are typical, not yours. Measure your real thickness and kerf and cut a small test in a scrap first: a square and one joint. How to do it.
Summary
Parts
Cutting sheets
Assembly
What you get
- At the starting size: Outside 16" × 11 1/4" · sides 2 1/16" high (1 7/16" at the center) and ends 3 7/8" high with a 3 3/4" × 1" handle · inside 15 3/4" × 11". 5 parts on 2 sheets of 24" × 12".
- An SVG with the cuts in red and the engraving in blue, and a DXF of every sheet, at real size and nested.
- A PDF assembly guide with the parts list, the cutting sheets and numbered steps, in your units.
- A license to sell what you make with the plan.
- Free 3D preview before you pay, and a fit guarantee: if a joint does not fit your material, we help you or give your credits back.
Questions
Is it strong enough to carry things?
Yes, if you glue every joint. Use wood glue on all the teeth and hold the tray with tape or rubber bands until it dries.
What material and thickness should I use?
Use 1/8" (3 mm) birch plywood, basswood plywood or MDF. Measure the real thickness with calipers and enter it under Material, laser and sheet, because the joints are calculated from it.
Do I need to set the kerf?
Yes, once. Cut a 3/4" (20 mm) square, measure it and enter the difference as your kerf. The joints are compensated, so the parts press-fit. The default suits most CO2 lasers.