Cut-out wall clock
A clock face you can make in an afternoon. Choose cut-out, engraved or no hour marks, add a ring of circles or rays, and set the hole to match your clock movement.
Before you cut: the starting values (a 3 mm sheet and a 0.15 mm kerf) are typical, not yours. Measure your real thickness and kerf and cut a small test in a scrap first: a square and one joint. How to do it.
Summary
Parts
Cutting sheets
Assembly
What you get
- At the starting size: Dial Ø 9 13/16" · shaft 0.315" · cut-out marks. 1 parts on 1 sheet of 24" × 12".
- An SVG with the cuts in red and the engraving in blue, and a DXF of every sheet, at real size and nested.
- A PDF assembly guide with the parts list, the cutting sheets and numbered steps, in your units.
- A license to sell what you make with the plan.
- Free 3D preview before you pay, and a fit guarantee: if a joint does not fit your material, we help you or give your credits back.
Questions
What size is the center hole?
Measure the shaft of your clock movement. Most use between 0.3 and 0.31 in (7.5 and 8 mm), and you can set it exactly.
What material and thickness should I use?
Use 1/8" (3 mm) birch plywood, basswood plywood or MDF. Measure the real thickness with calipers and enter it under Material, laser and sheet, because the joints are calculated from it.
Which software opens the files?
The SVG opens in LightBurn, xTool Creative Space, Glowforge, Inkscape and Illustrator. The DXF opens in most CAD and CAM programs. The sizes are real, so nothing needs scaling.